Wiremold is the surface raceway you run along a wall when a room needs another outlet, switch or light and the drywall is already finished. Homeowners, electricians and remodelers use it in basements, garages, older plaster houses and offices where fishing wire inside the wall is not worth it. The wire rides in a slim channel on the wall surface, painted or left ivory, and ends in a surface box.
Wiremold is a product line of Legrand North America and a sister brand to Pass & Seymour, Watt Stopper and Ortronics.
Channel, elbows and boxes
A surface run has four kinds of parts: the channel the wire rides in, elbows for turning corners, box connectors where the channel meets a box, and the switch or outlet box itself. Every fitting belongs to one channel size, so buy the elbows, connectors and boxes for the same channel you are running. The ivory metal channel takes paint well if the wall is a different color; scuff it and prime first.
The CordMate channel is a different job: it hides the low-voltage and appliance cords already running along the wall, like a TV cable or a lamp cord, without any new wiring. It sticks or screws to the wall and the cords press in from the front.
Running raceway so it looks planned
When you’re adding to raceway that’s already on the wall, measure its profile across the face and off the wall first, because fittings only fit their own series.
Plan every run, every box and every turn before the first cut. Pulling more wire into a finished run is hard, and a cover taken off and snapped back on tends to deform, so put each run together once. The elbows turn too tight for cable like Romex, so pull individual conductors and use the small wire nuts made for tight raceway boxes. Boxes come in two depths. Take the deep one when a receptacle and splices share the box. Wherever you run individual conductors, run a ground wire with them.
Commercial and outdoor lines
Wiremold, a Legrand brand, also makes aluminum multi-channel raceway for offices and labs, floor boxes and poke-thru devices, desk and furniture power, and outdoor power pedestals and ground boxes. The wall raceway is an indoor product, so power on a patio or walkway goes on the outdoor boxes instead.
Frequently Asked Questions
How do you install Wiremold raceway?
Fasten the base to the wall first, level and tight to the surface, and set the fittings and boxes before any wire goes in. Cut the base and cover with a fine-tooth blade, then file every cut edge smooth so a burr can’t skin the conductor insulation when you pull. Snap the cover on last, working from one end so it seats evenly along the run.
Can Wiremold be used outdoors?
The wall raceway is an indoor product, so outside work goes on the outdoor boxes and pedestals, fed underground from the building. A ground box sits flush in a lawn or patio with nothing sticking up to trip over or catch a mower, and the rooftop box serves equipment up on the roof. Put the outdoor circuit on GFCI protection, the same as any other receptacle outside.
Ready to Get Started?
Our building materials specialists can help you find the right Wiremold products for your project.